As the previous Vice President of TEC (2005-2009), it was my responsibility to make sure that all TEC coins are made on time and distributed to the deserving members.

Some of these coins were designed by me, as you can see in the photo albums below.

Some were also rolled by me. Especially after I purchased my own elongating coin machine, which hooks up to a motor. I can make a few hundreds elongateds an hour with this machine!!!

I also designed a few elongated coins for Coin Clubs, Coin Shows, Coin Dealers and a few very worthy causes (Angelman Syndrome Awareness and my very special THANK YOU FOR YOUR SERVICE Elongated Cents).

Please note the reverse side of some of the coin sets - these are "raised backs". The technique I use makes the reverse keep the design on it, and raise it, so it comes out looking amazingly good!

I enjoy designing and rolling these coins and I hope to continue doing many more in the future!

TEC MEMBERSHIP COINS

TEC JUNIOR BIRTHDAY COINS

MY TEC VICE PRESIDENT & PERSONAL BUSINESS COINS

COIN CLUBS, COIN SHOWS, COIN DEALERS and FRIENDS

CA MINI MEET - FEBRUARY 11, 2006

MY VERY SPECIAL PATRIOTIC & PERSONAL DESIGNS